Read Me File for LISST-SOP Software Disk


Installation Instructions:
(Turn word wrap on for easier viewing)

Run Setup465.EXE  and configure software:  Run the Setup465.exe program from the CD.  From the Start menu select Run and enter D:/Setup465.exe where D is the drive for the CD.  A Welcome screen will appear. Choose Next to continue to the Destination Directory screen.  The default directory is C:\program files\Sequoia\LISST100.  It is recommended that this directory be used. However, other directories can be selected. Use the Browse button to choose a different directory. Once a directory is chosen press Next.  Press Next again to start the install process.  When it is completed press OK to finish and exit the setup program. 

From the Start menu navigate to Programs then Sequoia Scientific then LISST.  If a desktop icon is desired, right click on LISST and choose “Send To” and then “Desktop as icon”. This will create an icon on the desktop for later use. Note: the “Start In” directory must be the same as the LISST.EXE program.  Start the program by double clicking on the icon or choosing LISST from the Start menu.  From the File menu choose Settings.  Select the File Locations tab.  The directory shown should be the same as the installation directory.  If it is not, use the Browse button to navigate to the correct directory. The default directory is C:\program files\Sequoia\LISST100. 

If upgrading from an earlier version of the LISST software be sure to follow the steps outlined in the Appendix of the LISST-100 manual or Quick Start Guide.  The software will not work correctly until these steps have been performed. Please note, existing InstrumentData.TXT files will be renamed PRE465_InstrumentData.Txt.  Existing LISST.INI files will be renamed PRE465_LISST.INI.

Please contact Chuck Pottsmith at pottsmith@sequoiasci.com with any questions regarding the software installation.